Deutz 1012 Especificações descarregar pdf (Página 223)

Service Training

Page 3

Section 4.8

4.8.2 LIFT CYLINDER REMOVAL, INSTALLATION

- Start the engine, operate the lift hydraulics and raise the fork carriage (8) approx. 1 metre.

- Pry out the retaining ring (1) of the cylinder to be removed.

- Block up the inner upright (2), operate the lowering control lever until the inner upright is supported by

the block and continue to operate the lever until the piston rod of the cylinder to be removed is fully

lowered.

- Disconnect the hose (6) at the base of the cylinder.

- Remove the bracket (4) on the outer upright (3).

- Tilt the cylinder (5) slightly to the side, sling a rope around the cylinder and lift the cylinder out of the mount

(9) with a suitable hoist (crane or fork truck).

- Installation is the reverse of removal.

- Bleed the cylinder when taking the truck into operation.

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 281 282

Sem comentários

Deutz 1012 Especificações Página 223