Deutz 1012 Especificações descarregar pdf (Página 168)

100

101

Page 10

Section 4.5

Service Training

4.5.5 BRAKE SHAFT STOP SCREWS

- Connect a low pressure gauge to port BR on the travel control unit.

- Slacken the clamping screw on the brake lever and turn the brake shaft (5) clockwise as far as the stop.

- Loosen locknut (2).

- Start engine. Slowly screw in setscrew (1) while at the same time holding brake shaft (5) clockwise against

the stop until the brake shaft has less clearance.

- Now gently screw out setscrew (1) while holding the brakeshaft clockwise against the stop until the

maximum pressure is obtained. Then screw out setscrew a further ¼ turn and tighten locknut (2).

- Adjust the brake pedal as described in "Brake pedal".

09.96

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 281 282

Service Training 1
353 804 2401.0906 282

Comentários a estes Manuais

Sem comentários

Deutz 1012 Especificações Página 168

Comentários a estes Manuais

Manuais e produtos relacionados com Motor Deutz 1012